- Single very compact universal 19″ 3U enclosure
- High efficiency switched mode current source
- Mains input voltage range 100-240V 50/60 Hz
- Serial ASCII interface
- Serial Modbus-RTU interface (upcoming SW release)
- Fully configurable arc parameters
- Arc current up to 30A
- Cutting frequency up to 200 KHz
- ISO-Frequency mode
- ISO-Pulse mode (same amount of energy in each arc strike)
- Single shot mode by external optical isolated trigger signal.
- Analog differential speed command output signal for CNC speed control
- Differential sense input for accurate arc voltage measurements
- All data I/O interfaces optically isolated
- Workpiece edge finding mode, with dedicated isolated output
- Switched 12V output for high voltage / EDM active warning light
- Firmware updates through USB interface (additional features will be released in the form of SW updates)
- PC application with material parameter library and lots of other features
- Self diagnostics
- Protected by hardware authentication and secure boot
- Reserved extra IO for additional future functionalities
- Stand alone mode (serial interface only required once to save the parameters in non-volatile memory, after that the generator can be used without serial interface).