How to clamp the work piece to the table?

< Back
You are here:
  • KB Home
  • FAQ
  • How to clamp the work piece to the table?

As EDM does not exert any forces on the work piece, clamping the work piece to the table is quite easy. The only forces exerted on the work are due to the water flushing. In The BaxEDM example machine, work is clamped to the table by simple screw type clamps that are adjustable in height:

The clamps themselves are of course Wire EDM cut by the machine itself đŸ™‚

Previous Can I use other motion control solutions than Dynomotion?
Next What is the typical wire renewal rate?
Table of Contents